Recent content by g3sys

so the fix was just to clear the codes? same thing happening to my 20 laramie 5.7 Etorque

Ahh crap ok maybe i will just cancel/return then for now.

mine is arriving this weekend will update you on my 2020

I have the dual 12 vented from Fox Hits pretty well

Drove on snow and ice, for first time with my new 305/45/22 ridge grapplers in the ADK last weekend and they were absolute perfection. High speed on icy roads, zero issues. I've had a lot of different trucks/tire combos, these are the best.

installed the 7709 on my 2020 limited with mopar 2" lift, put in the firmest position I can't beleive how much of a difference this bar makes, the truck handles excellent now.

I wanted to put an extang flush cover on mine and asked the dealer if those corner brackets were structural and they said they were not so i removed them. Are you sure they are??

Same here on my 2020 night edition with MFT, no step although sticker lists it in the bed group.

Reporting back with the 1" front and 1.5" Bora spacers as well They fit very snug into the hubs of the 22" wheels, you have to tighten one lug a few turns at a time to get them to snap in evenly. Other than that they are great, although i think i should have gone with 1.25" in the back, they...

Have a 2020 Night edition with the 22's i ordered 1" for front and 1.5" for rear for a flush even look, from Bora, should have them next week will report back with pics.

nevermind.... turned truck on and off maybe 5 times and it all came back, go figure

My sirius and cameras are all gone after adding a subwoofer today, did not drill anything so no wires pinched/cut only unplugged the factory sub wire and put a hi to low converter in for my amp put it all back to stock and still missing - anyone have any ideas???

Thx i agree i will contact Bora with this info I did read a thread where someone stated 1.5" worked without trimming but even these 1" units look like they would have cleared if the hub didn't rub.

Just to add to the 22" Wheel thread, i figured i would throw this info out there... I have a 2020 Night Edition with the 22's and bought some 1" spacers on amazon in hopes of a flush look... tried them this weekend on one of the front wheels, they would not fit inside the hub of the wheel...