Recent content by Fishstixs22

So I had all my sensors changed because they were starting to die and it will sync then all up and then randomly drop off one going clockwise all around and then re-sync up any idea what would cause that?

So the way I have found to do this with relative ease is to fuse tap your trailer turn signals on fuses F9 and F10 this will give you turn signal functionality with any lights also hazard lights when they are on . I have a 2019 5th gen 1500 Laramie . The pic is old but the middle light stays...

I doing the same thing and I believe the wires are located near the front head lights . There’s a video on YouTube by waterfowler41 that is pretty good for the day time running lights.

I’m in the process of adding these pod lights to the day time running lights and turn signals. Once I get it done and figure out which wires work I will post an update. I have a 2019 1500 Laramie quad cab with tons of add ons. I also have rock lights to add and I want to add some lights that...

So I have mine where your air intake filter would be I installed a ram air which opens up that entire side of the engine bay and installed a 2-1/2 gallon tank with the compressor since I don’t have ram boxes , works out great because of the ram air which isn’t a an insane amount of money to get...

Not this week but very recently added 8 device controller to my fuse box with the controller in the steering column area very easy to install rough country 8 Gang Switch Panel | RGB Backlit Buttons | Multifunction Modes Added the Putco molle Bed side rail system for storing off road equipment...