Recent content by Feltcycle

Thanks for the recommendation! That box would fit perfectly under the rear seat, but the calculated sealed volume would be a little small for the TW3 sub I’ve already bought. I’m currently working with Sound Off Audio in developing a 10” sub enclosure ~ 0.5 cu ft that should fit perfectly under...

Does anyone know of a prefab single 10” sub enclosure that will fit under the rear passenger side seat and not go all the way across the entire rear seat? I have found plenty of dual 10” options, but not many single 10” options.

I have the 6 speaker system and replaced all 6 speakers with recommendations listed here. I have CDT 69S 2 ohm speakers in all of the doors and I currently have JL C2 3.5”, 4 ohm, 83 dB sensitivity (bass blockers installed) in the dash. The dash speakers seem to be too bright and also too loud...

Thanks @Patsy1099! I’ll install the bypass harness when it comes in and hopefully that will be acceptable.

I have a base 6 speaker system with ANC. I currently have CDT CL 69S installed in doors and JL C2 3.5 in dash. Is it possible to install DSR1 in 6 speaker setup? Crutchfield is telling me the DSR1 is not compatible with 6 speaker system. What harnesses do I need with DSR1 to be plug and play on...

My truck is making this clicking noise now. It sounds like a sticking limit switch or a noisy relay. Has anyone found a solution? I don’t think grease on the pedal assembly is the solution to my noise.

Ok. The screen shot part number you posted on the first page showed 84705 which is 1/2”. Just making sure I needed 84706 (5/8”). Thanks for sharing your fix!

@KcRay Is there a reason you used the 1/2” cutoff valve for 5/8” heater hose? I assume it’s 5/8” ID, but I could be wrong.

Does anyone know the torque specs for the sway bar end links?

Thanks. That’s sounds like the best option in the future if I find myself wanting more out of the system. Disconnect ANC and install an amp. Hoping the 2 ohm speakers will be satisfactory with the factory HU unamplified, but I’m sure those speakers will need power to shine.

Has anyone successfully installed an amp on the 6 speaker system while keeping the ANC and factory HU? I ordered the same system @lrobbi recommended minus the sub. Looking for ability to amplify in the future.

Mine has a smell near the rear passenger side. Doesn’t smell like weed to me, smells more like brake pads. Brake calipers and rotors did not feel too hot. Hopefully whatever it is burns off. 2019 Big Horn, 5.7, 7/18 build, 300 miles.