Recent content by Eaglehemi345

It depends on various factors. Winter fuel, extreme cold, city driving, full time 4wd, mds off etc.

Truck computer calculations are very accurate. Maybe manual calculations will give me a little better number

I have 2020 ram 1500. 3.92 gear ratio. Driving in 4wd auto in winter. Mds turned off. 85% city driving. Remort start for 5 minutes daily. Fox 2.5 inch coilovers all around with falken wildpeak at4w's 325/65/r18. Temperature does go down to - 35F (-30C) in winter time. Truch has 39k miles (63000...

Recently did fox 2.5 inch suspension lift on 2020 ram 1500. Paired with trx wheels and 325/65/r18 falken wildpeak at4w's. Belltech rear sway bar (BEL-5563) 1994-2002 ram rear sway bar links(zon-D5508) Bilstein B12 1" lift springs (53297839) Icon delta joint tubular upper control arms (218550DJ)...

Never using this shop again. showed it to them and they said its normal and can do nothing about it.

Shop scratched brand new wheels during installation. Machine gouges at 4 different places along the rim. Is it normal?

Vht spray taillight tint, sanding, 2k clear coat.

Tried adjusting the preload but the adjuster ring doesn't even budge. I was able to put one spring comprssor arm to take some tension off the ring but still not turning. using a 5/16 punch. Is it suppose to be that tight? I m waiting on another type of spring compressor and adjusting tool.

How much space you have between control arm and tire. I have trx wheels with wildpeak at4w's. Just not sure what is the thinest spacer i can run without rub.

Does anyone have fox 2.5 elite series coilovers installed on their truck(2-3inch) with 2.5inch front lift? I just installed them on my truck. Bought them used and the guy said they are set for 2.5 inch of lift at front. After installing them they lifted the front 4 inches. Exposed threads on...

Anyone running wildpeak At4ws?

Hi everyone. I have oem trx wheels and tires that i will be installing on my 2020 sport with 2.5inch lift in the front and 1 inch in rear. Does anyone know how thick of a wheel spacer do i need? I will be using icon tubular upper control arms as well. Any inupt is appreciated. Thanks.

How much power you were making at the crank roughly? Because 8HP75 is rated to 510hp and 520tq at the input shaft.

I'm going for eibach coilovers for now. They are decently priced. If i need i will add on a 4 inch later down the road. But 3 inch should be enough to clear 35's. Plus the benifit of coilovers.

He mentioned 3.2 inch in the front and 1 inch in the rear on non rebel trims. This could give a squated truck look. I believe if rear can be lifted to 1.5 inches that should leave some rake.