Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Ran into this today. It was a foggy morning, mirrors were coated with condensation. Took about 15 minutes for passenger mirror to clear fully, driver side barely was half cleared and by then I had reached my destination. Pretty poor.
Yep, one of the few times I am jealous of my wife and her iPhone. I prefer Android overall but when we ride in the car together, I make her use her iPhone for the console so it's full screen.
RAM needs to get their **** together and enable full screen with Android on Uconnect because it looks...
Cool. Pretty slick. I might wire in some additional led strips as I have some spare from an old job that I can splice into the one I did.
I wired mine into the bed cargo light wire so it's controlled by the cargo switch. Added a switch to be able to turn off as well.
It's working! I got it working! I took everything apart again. Checked the connections, checked the cap to make sure it had the magnet (it did). Rechecked the wiring (Jimmy's harness was correct and matched the diagram). I confirm the locations of the wires, re-seated them again (for like the...
So I tested the continuity of the cables. No problem, both wires and connectors were fine and the connectors are still solidly connected.
So while I was testing the continuity, it occurred to me to check the wire color vs the wiring diagram for this project. I ordered the cable harnesses from...
Pretty sure it's got to be the wiring (most likely I plugged the wire into the wrong slot or it didn't seat properly).
I actually disconnected and re-connected the handle twice, and also tried swapping it with the other passive entry handle that I got for the passenger side just to make sure it...
OK, checked the settings on Uconnect, passive entry shows there as follows. See attached image.
I'm starting to think I got the wires swapped. I put the pins in and took them out like 5 times because I kept forgetting to route the wires through small openings first and had to redo it. I...
I missed that, I didn't know you could check the setting in the UCONNECT screen. I will check that on my next break between work calls.
II did go through a 2nd time on by one and reflashed with AlfaOBD again after it didn't work the first time to double check the settings and to make sure I...
Yeah, that's kind of what I was thinking. The passenger door passive entry setting was the only one in AlphaOBD that didn't stick.
I'm not looking forward to taking that wire harness off the door again, it's a pain in the butt to take off and put back on. I had to do it 3 times yesterday...
I mean there is glue between the clamps and the glass. The bolts loosen just fine, but the glass won't move when I lift on it. When I did the driver side, the glass came right out. When I losen the bolts and pull up on the glass on passenger side, the glass does not budge.
Having a bit of trouble.
Finished the installation of the driver side passive entry door handles and went thorough ALPHAOBD perfectly fine. The driver side passive entry is not working.
I decided to get started on passenger side and then ran into a different problem. The window for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.