Recent content by Dimebag430

This is the link for the rear spacers. I got the UCAs without the rest of their kit on Amazon. [SR] 09-18 Dodge RAM 1500 4WD 2WD 1" REAR COIL SPRING LIFT LEVELING KIT (BLACK) https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F302954450872

I don’t have the measurements after putting on the new tires/wheels yet, but I was just over 39.5” in front and 40.75” in the back with the stock ones. I didn’t get a full 2.5” of lift up front, but it was pretty close. And I definitely paid a heck of a lot less than they want for the full...

They’re Ironman All Country M/Ts and they are knobby AF! But based on what I saw on the forums, I expected some rubbing. I got it 90% fixed today though. Just have a little bit of rubbing in reverse at full lock. Gonna fix it the rest of the way tomorrow.

Well, I didn’t get a full 2.5” out of the front, so I have a little more take left than I’d like, but it’s nothing drastic or anything. I’ll probably be fine with it once I get the full rear wheel-well liners. I think it’ll be less noticeable then.

Correct. Which is what I was going for. But to be honest, I may be regretting doing the 1” in the back. But I just did it today, so we’ll see how I feel about it in a week or so. I definitely have a little rubbing up front though, so I’m gonna have to get out there tomorrow and massage some...

ORG, Ready Lift UCAs, 2.5” Motofab spacers in front, 1” spacer in back, 35x12.5R20 Ironman All Country M/T, Fuel Warrior 20x10 -18 offset

And this will also fit the ‘19?

I’ve seen multiple people reference having installed a 1” rear lift on their truck, but visiting websites for companies they’ve referenced hasn’t yielded any results for me. Can anybody who has installed (and is happy with) their 1” rear lift provide a link or any additional info? Thanks!

I haven’t really seen anybody mention this tire size on this truck and I’m kinda wondering why. I had a 2016 with Bilsteins set at 2.1” with a set of these tires on my stock 20” wheels and I loved them. No rubbing, no trimming, no nothing. Are the wheel wells on these trucks smaller than gen 4...

That's a good lookin truck. Do you have the measurements from the ground to the wheel well? If not, would you be willing to take them? Also, have you had any issues with this setup? Rubbing, bad UCA angles, etc?