Recent content by dearmosd

Hummmm, I thought there was a connection near the fire wall. I had this from someone else but crappy clarity

I cant find a diagram that I thought I saved, but there is a connection point in the engine bay that I can use for turn signal power, I cannot use the fuse box because that turn signal is tied in with the brakes for trailer connection purposes. Does anyone have or know the connecter in the...

Thank you for the update. Helps other to decide on the choices that are out there.

following in case I ever go this route.

I ended up with Arena Cobra Satin Black 20x9 0offset with 275/60/20 Bridgestone Ascent tires. 95% satisfied, with a 0 offset I was hoping for a more flush look which the front is right about what I wanted but the rear are not as flush. Just ordered 1/2" spacers for the rear to hopefully match...

I didn't separate the screen from the digitizer but there are three ribbon connections on the screen/digitizer combo which I was hoping to find a all in one replacement but many combos I saw had one or two connectors or if three were in different locations or sizes, nothing a 1:1 look.

I looked on Amazon and many of the ribbon connectors looked different so figured it wasn't a good fit or inaccurate verbiage on the site.

might just sell as a bezel/module only then

I had a UC4 8.4" with NAV delaminate so I upgraded to the 12" UC5, but after shopping for a new scree to replace and resell the screen, bezel and module I question is it worth fixing. Seems the screen from a reputable place is $300, I was hoping to get a cheap screen and replace it and sell the...

I recently upgraded from 8.4" to 12" radio and noticed the rubber insert that fit my 8.4" radio bezel does not fit in my 12' bezel, seems the 12" cubby tray is a little smaller. Would anyone know the part number for the little rubber tray that sit inside the cubby on top of the radio bezel?

I just upgraded to UC5 with 12" screen from a UC4 8.4 but noticed when using Bluetooth for phone calls through the system the far side complains its hard to hear me, when I have the phone plugged in via USB they say I sound great.....anyone else notice that difference?

I installed a set of Total Flow black exhaust tips but the OEM clamps are tight but not tight enough and the tips move when hitting bumps. I once read on the forum people with same problems and some solutions but cannot find the post again. Anyone seen the posts or have suggestions on how to...

Did you ever find a solution, I am in the same boat now, went with TotalFlow tips and ever so slightly loose and move when hitting hard bumps

ANy update?

my vote is this Performance Brake System | Front | Ram 1500 2WD/4WD (2019-2024)