Recent content by david0

My rear seats don't recline either - Crutchfield and ABT just don't have the full product description. If you look at JL Audio's website, the description for the 12" model says: I have the non-reclining rear seats, but I do have the underseat storage... I didn't want to add the additional seat...

Finally finished my install! Just some final notes on the installation process for anyone else looking to do the same... Removing the front screen panel of the truck to installing the PAC AmpPRO SUB module was fairly easy, and I feel much better knowing I have a flat signal going to the...

Just an update on my install... So, it WAS a phase issue, but not one of my doing. The Stealthbox came from the factory with the two subs wired together incorrectly inside the box, which put them out of phase with each other, and effectively pitted them against each other when producing sound...

Interesting - Crutchfield says that's not a fit for my Ram. So, I finishing my install last night and promised to follow up after I was done. Here's a summary of how it went including some details that I think might benefit someone in the future. Rant/Initial Review Overall, the install was...

Do you have a link for that Kenwood amp? The only item that comes up under the category "Vehicle-specific amps & processors" for me is the DSR1 module.

You're right - that looks like the right one! Here is the link for reference: https://www.crutchfield.com/p_541APHCH03/PAC-APH-CH03-AmpPro-Harness.html Thanks for sharing the video! That was very informative. Now you have piqued my interest in the DSR1... but I'll try out the CH03 harness...

I was also wondering about the compatibility, but the poor instructions left the possibility of it working with the Alpine system open ended. My interpretation of the installation notes was that it's not for aftermarket amplified systems, but was okay for the factory amplified systems. However...

I am not too happy with the ANC-CH01 harness. First of all, the instructions suck - it says to disconnect the 22 pin connector from the ANC and connect the harness to the disconnected plug, but there are two 22 pin connectors going into the module - one grey, and one white. It doesn't say which...

I am trying this out for my '19 Rebel with the 12" touchscreen and factory Alpine system. I've been browsing the forum for several days as I plan my install, and there is a lot of confusion that makes it hard to know what will work and what won't. I only found this thread because of a link...