Recent content by Chidds

Hi Everyone, I have a code PO 200 A and B Scanned the vehicle and it is the swirl valves, my question to everyone is what do people do with their intakes at this point? Replace, only aftermarket right not available , any success with them, what are people using? Clean it? Not deleted, going...

Thank you for your input on this, Cheers

I do agree with the regearing with this, but would rather put the money in a tuner if possible maybe add a few LBS and HP Looking into a EOC tuner as we speak. This help?

I do have access to a snap on Zuse scanner but have not seen anything to change the tire size. Has anyone been able to change tire size with this scanner?

Thank you very much for your suggestions, I will look into this tonight. Cheers

If I put the tow/haul on it will stay in 7th for sure and will rip through fuel and revs are up. The sled trailer is not that big, just enough drag on the truck to only allow 8th gear down a hill or on flat highway.

Hi everyone, I have a 2020 Rebel and was running my stock Duratrac's tires and got 90km out of them, I liked them and the performance I got so i wanted to stay with them, I found a set of 285/75/18 new on MP and put them on knowing they are a little larger than stock 33.2 inch to 34.8, they...

Happy new year everyone! Just a update, I ended up replacing the front right air bag, the reason for this was it was always the lowest in the morning and I took a shot that it was the problem. I replaced the leaky manifold , I replaced the rear air bag that had a very small leak through the bag...

Thanks so much for trying to help me find the root of this problem. I was jus using shop air to fill the system up and agree temp can cause the PSI to lower for sure. I live in Canada so our temps do go up and down but this has been a problem when it was warm and now in the cold doesn't...

Hello everyone, I have a 20 Rebel 3.0 D W/air ride. My issues that I am having with this vehicle is the front end drops overnight and the back end stays up. I have gone ahead and looked it all over with a soapy water bottle and found a couple of issues. 1. The manifold was leaking around the...