Recent content by bryan28

So i took measurements again today and this is what i got. On drivers side the rear is 39.5 and front 38.5 (which I like). On passesnger side both are right at 39. Is this normal? I'm going to take it to a shop Thursday morning and was planning on them taking the struts down one ring but now I'm...

Yeah most the weight is on the back of the boat.

I appreciate all the advice. I think I'm going to end up having them redo it and lower the ring one notch. I don't want the rear end any higher.

I'd feel bad about having him tear it apart to do it again since I set the rings. And I'd hate to have to pay for it again.

Mine doesn't look high but it is dead level. I only tow a 3k lb boat so it shouldn't squat much. I was hoping for an inch or so of rake.

No ORP.

Had Bilsteins put on todsy set at level 5 (1.7") and added Cooper Discoverer AT3 4s 275/60R20. The mechanic swears he put the Bilsteins on correctly. They had instructions in the box he said he used. We measured all 4 corners andcall were at 39" from the ground to the bottom of the fender...

Will do. What wheels are on your truck and what size are they? They look really good IMO.

I'm having the Bilsteins installed at level 5 (1.7") and having the Cooper Discoverer AT3 4s in 275/60r20 put on as well on Friday. Can't wait to get it done.

On Friday I'm finally having the Bilsteins installed at level 5 (1.7") and will be having Cooper Discoverer A/T3 4S put on my 2020 Laramie. Will be going up from the factory 32" tires to a 33". Nothing drastic but I'm excited.

Did you measure the tire by using chalk marks on the tire and pavement? I did with my Hypertech and the speedo was spot on at all speeds. Just because a tire is labeled as 35", for example, doesn't mean it is actually 35" diameter. And I'm not sure what "everytime you take it in for service...

I haveca 2020 Laramie 1500 that needs new tires after I add Bilsteins at 1.5" up front. I like the way the Rebel tires fill the wheel well. Aside from being an 18" wheel are the dimensions of the Rebel and Laramie wheels the same? I believe the Laramie wheels are 9" wide with +19mm offset...

Anyone have any opinions about the Americus Rugged ATR? Saw them at a local shop and they look decent but there's not much on them online. They are made in Thailand. The shop said the 33x12.5R20 has a 40k mile warranty.

Why won't a dealer sell if it's going to be exported? A sell is a sell in my book. As long as they get their money why care where the vehicle is?

Wouldn't that be exported to Europe.