Recent content by bigdaddymac

Did the same yesterday. Radio comes out with 2 screws and some careful pulling. Then I just moved the connector a bit and now I’m working again. Thanks @Ultra-Harley

5 year anniversary coming up so decided to upgrade some suspension parts. RC M1 loaded struts up front with new UCAs. M1 shocks and full 6” lift progressive rate coil in the rear. Wednesday it goes in for new rear sliding window, new 8.4” Uconnect, new 3rd brake light and new exhaust...

Just got them on today but I’m happy. And thank you! I like that blue you got.

After 45k plus miles I got new Nittos. Went from the Ridge Grappler in 35x12.50r20 to the Recon Grappler in 325/60r20.

I know this is an older post but pulled the trigger on some Nitto Recon Grapplers in 325/60r20. Switched from 35x12.50r20 Ridge Grapplers. Slight rub by the pinch weld and on the liner but nothing a little heat gun and trim won’t fix.

No complaints. Granted I only have 35k on the truck but I have taken it on family trips, highways and everything in between. I am considering 37s though and the upgraded preloaded coil kit.

Mine just did it but was after I needed a jump. Bought a new battery and I’m good to go now.

Im in West Cobb quite a bit. That’s a good looking Limited you got there.

Rough Country 6”

No regrets but I would probably try to do 37s after these 35s are done. You won’t be disappointed though. Great trucks!

Mine has also started to do it again and its getting worse. My dealer used to be great but they let the whole service dept go recently so I am dreading taking it in.

Big thanks @2020Larrie - my morning stumble on a cold start is fixed!!

B2 resonator delete and 5” polished tips are installed. Adds that nice deep tone and no drone.

Add Hemifever tuning to my mods list now. Ordered just the PCM tune yesterday morning then got an email from Sean recommending the transmission tune as well so I added that. From original order to my email ready to install in less than 2 days. Only driven once for 5 miles but I’m pleased and...

Working on that this week