Recent content by 91TTZ

Same here. 2022 get the same message comes up one time for every start of the engine.

22 larmie. Non etorque. Air ride that's leveled or raised a bit. 33 nittos. Got 17.4mpg hwy yesterday 65 to 75mph. 3.92 gears. I think the truck sits in off 1 in aero mode as I have no off road 1 or 2. Had this truck about 3 weeks. City hasn't been so great but bad traffic and lots of lights...

Thanks everyone. I have them around 40 and the ride seems good. I will play around with the pressure a bit and see what feels best. Maybe 45 or 50 and see how it performs. I figured nitto would know best. I told them the year and model of the truck.

Recently purchased a 22 1500 laramie with air ride. Tires on it are the nitto recon grapplers. 33x12.50r22 max psi of 80. I know the door Jame says 36psi front and rears. I emailed nitto the sent me back this Does 58psi sound good to you guys? Such a wide range. Was seeing if anyone here have...

I have felt this as well, but I only notice it when I first start the truck for the day. I always let it sit for 30 seconds or so before I drive, but it seems to lunge forward as I pull out of my spot when letting off the brakes.

Thanks for these. Yes I did measure the front and rears, they were almost all exact. So there must be some level kit or spacers. I will check tomorrow to see if I can raise the truck to offroad 1 and 2. Your truck is set up like it should be, the rear suspension is always higher in the rear from...

Yea I think I will do that, I am only a few miles away from a big dealer with tons of rams. I'll check out some limited trucks and see how they look around the air spring. Very well could be some kind of spacer as I getting an fault when trying to go to off road 2.

I think maybe my truck is leveled. Front and rear tires are very close in height for all levels. I haven't tried to go to off road one or two since the dealer reset the air suspension. Going to take a look tomorrow. I posted some pictures of the suspension, a few said the links look stock. So...

Says my trucks recall for 14a was completed. I still get the message. It comes up only one time during driving. Calibration failed see owners manual. Anyone else still have this message after recall? I've only had the truck two weeks it has the trailer tow package.

This is aero height just over 39 inches. This is normal height This is entry/exit Fronts and rears are about even in all modes. I think the truck sits up higher than stock. Tires are only 33 inch. If they are all even Maybe the front is leveled? Not sure on the stock height numbers from...

Yea I will take a good look tomorrow, it does look cut a little bit in that section. Wonder what the reason would be for that? I'll see if the passenger side matches. I have test drove two limited 1500s. In normal mode on my truck it seems bit higher up. Appreciate you guys chiming in. Haven't...

These are some cool options. My wife's step dad has an f250 with some really bright lights in the back and a light bar in the front. I guess I wouldn't call them reverse lights because he has to turn them on with one of the aux switches. They are bright though and look clean.

Hey thanks, I'll measure it in the morning. Had to work last night. Rims are 22 inch and tires are 33s. The dealer that I took it for service said the wheels and tires are not that much out of spec. Maybe some level kit was done in the front? They told me everything looked good and did a reset...

That's a shot of the drivers front. Everyone said it looked normal. I had trouble getting it into of2. Took it by the local ram dealer they reset the air suspension. And took care of the calibration failed message that would come up when you had no trailer attached. I think it sits up higher...

Yea a 23 ft. world cat boat. It's about 7k lbs with the trailer, fuel and gear. Tow about 6 times a month.