Recent content by 22Ram1500InAR

I own, and I am comfortable using AlfaOBD. Nonetheless, I chose to have the dealer program the trailer brake controller and my LED bed lights. Both of these are ‘dealer installed options’, and after the dealership’s programming, both options show up on my ‘build sheet’. They programmed both for...

Worked for me too.

My problem was exhaust moving around in bushings, and can't be fixed apparently. Just got the oil changed, and two techs told me this. I may need to live with the creaking noise. Sorry I can't be more help this time.

You can put together your own kit for cheap. Double check part numbers. https://5thgenrams.com/community/threads/installing-factory-trailer-brake-controller-and-diy-software-update.12100/post-720347

I have not got under my truck like you have, but this is similar to a noise I have that started one or two months ago. I am close to an oil change, and I am having it checked out. I’ve searched through tons of threads and you are the only person I believe that has captured/described a noise...

I thought someone might ask. I’m a purist. Now when I check the VIN (build sheet) for my truck through RAM it shows the trailer brake controller and LED bed lights. In the unlikely event I need my body computer restored these things would be restored as well. I’ve run harnesses, added sensors...

I apologize for the slow reply. I asked my local dealer if I purchased the kit if they would install it and they said yes. I purchased all the Mopar parts separately essentially creating my own kit. They could not tell the difference. Totally worth it in my opinion to have them install and...

I just installed the Mopar 82215698 body side moldings for my crew cab 6'4" bed. $250 plus tax free shipping on eBay. This video was helpful for install tips and tricks. I used sticky post-it notes for alignment instead of masking tape. Just draw a 4mm line along the post-it or crease it at...

Today. 100% city.

I installed mine today. I found this short video super helpful (link below). The bolts are tight, but a 25 in breaker bar made easy work of it. Harder to torque when reinstalling the bolts with a 18 in torque wrench but not impossible. I like it. Time will tell. Oh, it’s the Mopar model $335...

Well, I’ve only seen one other v6 crew with the 6-4 bed. Also that configuration was no longer available at an after 2023.

Those utility rails can be a pain to install. This thread helped me and I tried to contribute as well. Make sure to read it especially if you don’t have a lot of experience with rivet nuts. Thread 'Bed Utility rail installation' Bed Utility rail installation

I have a 22 crew cab with 6-4 bed. Very rare configuration. It is powered by the v6 eTorque. It’s fine. I consistently average 20 to 21 mpg nearly all city. I average about 23 combined. I pull a 20’ fish and ski with single axle trailer from time to time never had a problem.

I used “334AA”. See my post #220. They work well. https://5thgenrams.com/community/threads/rain-sensing-wipers-not-equipped-but-have-the-part.8788/post-740400

See this thread regarding parking sensors. Seems pretty straightforward. Kind of pricey option tho when added as not part of a package. Over $1k parts in my case. Thread 'Adding front and rear parking sensors?' Adding front and rear parking sensors?