Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I did a similar thing for my Crew Cab. Plywood base that rests on the floor, covered with a high density foam pad and felt automotive carpeting. Built it the same height as the backseat so my pup can sprawl out in the backseat. Only extended it past the center console to make entry and exit a...
Installed the Hellwig 7709 Rear Sway Bar. Took about 30 minutes--mainly because I couldn't find my 8mm socket to remove the end-link bolts. So out came the 8mm box wrench and an adjustable crescent--what a PITA (but all my own fault).
I set it on the middle setting, to give it a trial run this...
i would unbox it and try a dry fit to see how well it fits. i moved my 4th gen (2016) full bed rug to my 5th gen (2021) and it fits just fine. had to do some minor modifications but it fits great:
1. cut slits for tie down hooks
2. cutout for two factory bed lights
3. cut slits (3 or 4 on each...
same situation here wanting to go from chrome to black. i think i'll try Plastidip here first before i drop $100 on plastic emblems. most people rough-tape them off, paint them with Plastidip right on the truck and peel off the excess. just need to wait for it to warm up here a bit in PA before...
I finally installed the Pop & Lock PL9772 Keyless remote entry kit for my Ranch Icon Cap. Super easy to install--really only took about 30 min since I had already run wiring and tapped into the Lock/Unlock wires in the B pillar. I love being able to lock/unlock the cap without fiddling with a...
yes. you can run a ground wire anywhere from the frame. either use a self tapping screw and drill directly into the frame or find another bolt nearby. i used one of the bolts that secures the spare tire shield near the rear of the truck as a matter of convenience, since i was already running a...
Finally wired the 12v dome light--just tapped into the wire supplying the factory installed bed lights at the driver tail light assembly. Just traced it back from the LED--really easy to get to since it's enclosed in a split cable loom. Functions along with the factory bed lights--Exactly what I...
https://www.kurgo.com/dog-harnesses/enhanced-strength-dog-car-harness/
For those looking for recommendations on a dog harness for the truck--Kurgo has a solid option. I really like their stuff in general--very durable. Their "Enhanced Strength Tru-Fit Dog Car Harness" fits well, has STEEL...
looking to add a blackvue dr750x-2ch dash cam for general protection from idiots (both driving and parked). anyone know if i can place the rearview camera inside the cab (probably on the rear window out of the way of the slider) even with a Leer cap on the back? or would i be better off running...
https://www.chewy.com/kurgo-extended-width-dog-bench-seat/dp/143179
Kurgo Extended width bench seat cover. Fits well. Secured above with straps around headrests, below with adjustable bungees under the seats. Two attachment points at rear of seat to keep it in place. Extends over the sides of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.