Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I know it is a hideous task but reading the 20 pages of the threat is of great help ;). Plus, reading:
improves brain connectivity.
increases your vocabulary and comprehension.
empowers you to empathize with other people. ( I don't read enough apparently🤣)
aids in sleep readiness.
reduces...
That is normal behavior. It will always be around 14v when the alternator is running and 12v when vehicle off but it should not be dropping below 12v quickly unless you some heavy power consumption after off(lights, compressor, inverters, etc) When you get that voltage drop for no particular...
First of all you might want to check that, voltage should not drop below when shut off unless you have something consuming power. All my switches are set up to work only on ignition so they will only turn on when there is ignition power. Also you can set the low voltage shutdown voltage on the...
You do have to remove the door handle(that is the easy part) with a long T25 torx bit or a T25 torx screwdriver, a short torx bit wont work, the hole in the door is too small to fit a bit holder. It does take sometime. I have not done the rears yet but is the same process.
The painters tape is to hold the window up in place since you have to remove the window carrier panel if you are going to sound deaden (you should) the interior of the door.
This thread was of great help to figure out hoy to remove the window carrier panel.
Passive entry how to
This video will...
Thanks! I don't know what type of bass boosting you are looking for but this things sound amazing. I'm am a bass heavy fan, not brain blowing but punchy bass kind of fan, and this things can go loud!. Beyond anything I will ever set them to do. Sound deadening helps a lot too to keep it clean...
After reading all possible posts of Harman Kardon system speakers replacement. I decided to give it a try to replace just the dash speakers and Went with the following phase 1 setup:
-Sound deadened doors and rear of cabin floor and rear wall. Dynamat extreme. 60sq/ft of Dynamat to sound deaden...
I know that feeling, it sucks when it does not sound how expected. The XR600 has a pretty complete DSP. Try using an RTA app from the phone to see how those slopes are in real time and setting those time delays. But if you are not pleased, back to the drawing board and start over. Been there...
Hello found you in this thread. Quick question, why did you go with tweeters in doors and mids in dash? Better staging? Did you try them the other way around. I'm afraid tweeters in dash will be too bright and mess up staging.
Great system!! Love those Helix DSP amps. You have a taste of every country's hi-fi audio there. I'm biased with Morel Hi-Fi, have been using them for quite some time with great results. Let's see how everything comes out. (y)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.