Recent content by Peasey

Buy the eliminator, or does Pulsar do as well with added functionality?

Any issue with rear parking sensors with these lights mounted in that location?

Magnaflow 18", part number #14264 welded in. Also, be sure to have the weep holes welded in the resonators, or it will sound terrible like an exhaust leak standing behind it. Sounds great now!

Anyone have Mopar Cab Length Steps, part #82215291, installed with Mopar Splash Guards? Will they fit with guards installed? Pics if possible.

Ok, so the update is the install went very smooth. Just remove the front pieces, separate the back pieces and put back in, and install all the screws. Put the rear flaps on at the same time. Easy as that. The video that was posted gave enough information to figure it out on a Big Horn vs...

Max pressure? I would think they would wear in the center of the rears?

So did you have to separate the back pieces like the video? Is the front 2 pieces as well? Or did you just go over the existing and put liners between current and fender and screw them in?

Best tire pressure for Falkens?? Door tag 32 psi, or????

Its actually a Big Horn. The video on youtube has flares, so I'm sure it wont be too hard to figure out the changes. Just trying to make sure I have everything needed before doing the install.

Does that mean I will need to get extra clips, or do you take them off the new liner where they match up with the existing shields?

So do both the front and rear mini splash shields get separated on a Big Horn and put back in behind the liners? Or is it just the rears that go back in after separating?